Faculty of Civil Engineering, Department of Geotechnical Engineering, Vilnius Gediminas Technical University, Saulėtekio al. 11, LT-10223, Vilnius, Lithuania
Faculty of Civil Engineering, Department of Geotechnical Engineering, Vilnius Gediminas Technical University, Saulėtekio al. 11, LT-10223, Vilnius, Lithuania
Faculty of Civil Engineering, Department of Geotechnical Engineering, Vilnius Gediminas Technical University, Saulėtekio al. 11, LT-10223, Vilnius, Lithuania
The article analyses a possibility of replacing a part of cement with fly ash in jet grouting piles, because the received strength of cement treated grout is much higher than it is necessary for these piles. The paper presents the problems of fly ash utilization, overviews experimental and theoretical works and analyses laboratory tests on the samples of cement treated grout. The conducted experiments involved manufacturing cylindrical cement treated grout samples containing different additives when the diameter of the cylinder is 35 mm, and its height is 70 mm. The experiments on the samples comprising the additives of fly ash were made in sand and clay soils. 25% to 75% of cement was replaced with fly ash in cement treated grout samples tested under compressive strength following 7 days hardening in air.
Marčiulaitis, V., Sližytė, D., Mackevičius, R., & Zhilkina, T. (2016). Research of cement additives influence on the properties of soilcrete. Engineering Structures and Technologies, 7(3), 140-145. https://doi.org/10.3846/2029882X.2016.1144486
Authors who publish with this journal agree to the following terms
that this article contains no violation of any existing copyright or other third party right or any material of a libelous, confidential, or otherwise unlawful nature, and that I will indemnify and keep indemnified the Editor and THE PUBLISHER against all claims and expenses (including legal costs and expenses) arising from any breach of this warranty and the other warranties on my behalf in this agreement;
that I have obtained permission for and acknowledged the source of any illustrations, diagrams or other material included in the article of which I am not the copyright owner.
on behalf of any co-authors, I agree to this work being published in Engineering Structures and Technologies as Open Access, and licenced under a Creative Commons Licence, 4.0 https://creativecommons.org/licenses/by/4.0/legalcode. This licence allows for the fullest distribution and re-use of the work for the benefit of scholarly information.
For authors that are not copyright owners in the work (for example government employees), please contact VILNIUS TECHto make alternative agreements.
